PVA (yellow and white wood glue)
Titebond Cold Press for Veneer
The figures Franklin International (Titebond) prints for Titebond Cold Press for Veneer on its own specification sheet, at the conditions it names. Where the sheet doesn't give a figure, this page says so rather than borrow one from another product.
- Open time
- 15 min
- Total assembly time
- 15–20 min
- Clamp time
- Not on the sheet we read
- Cure
- Not on the sheet we read
- Lowest temperature
- 50 °F (10 °C)
- Water resistance
- Not recommended for exterior use or where moisture is likely
- VOC
- 2.0 g/L
- Conditions
- 70 °F, 50 % RH
- Food contact
- The sheet we read makes no food-contact statement
One source: Franklin International (Titebond), the maker of that product
From the sheet: A modified PVA for pressing veneer.
Related
- Every glue side by side: wood glue dry time chart
- Glue types and how they work: wood glue
- What Type I and Type II water resistance mean: Type I vs Type II glue
- Titebond Original, II and III together: Titebond comparison
Work it out for your project
- Plan the finish for your project
Pick the piece and the wood, then get a dated coat schedule from the product’s own sheet.