Howard Cutting Board Oil
The figures Howard Products prints for Howard Cutting Board Oil on its own data sheet, at the conditions it names. Where the sheet doesn't give a figure, this page says so rather than borrow one from another product.
- Dry to the touch
- Not on the sheet we read
- Recoat
- Not on the sheet we read
- Ready for use
- Not on the sheet we read
- Full cure
- Not on the sheet we read
- Coverage
- Not on the sheet we read
- Thinning
- Not on the sheet we read
- VOC
- Not on the sheet we read
- Conditions
- Not on the sheet we read
- Indoors or out
- Not on the sheet we read
- Food contact
- “Meets all requirements for USP Light Mineral Oil, National Formulary (NF), FDA 21 CFR 172.878 and 21 CFR 178.3620 (a)” (21 CFR 172.878 and 178.3620)
One source: Howard Products, the maker of that product
From the sheet: 100 % USP mineral oil, for the first oiling of cutting boards and butcher blocks.
What the maker names it for
- For: cutting boards, butcher blocks, countertops.
Against its kind
Howard Cutting Board Oil is one of the products in board oils and bowl finishes; here is that kind across every maker we have read.
Board oils and bowl finishes: recoat across makers
Only one maker’s sheet so far, so no class value: see its own figure above.
Board oils and bowl finishes: coverage across makers
No maker we read prints a coverage.
Related
- Every product of this kind: cutting board oil
- How much to buy: finish coverage calculator
- Every finish side by side: finish dry time chart
- What the federal rules say about finishes and food: food-contact finishes
Work it out for your project
- Plan your coats of this finish
Pick the piece and the wood, then get a dated coat schedule from the product’s own sheet.