Lathe speed by blank diameter
Lathe speed for a 6 in blank
Spindle speed for a blank 6 in (152 mm) across, for roughing, general cutting and finishing, from the speed charts in lathe makers’ manuals. Start slower for an out-of-balance blank, and your own lathe’s chart is the authority for your lathe.
Speed by operation
| Operation | RPM | JET | Grizzly | Delta | Basis |
|---|---|---|---|---|---|
| Roughing | 450 | 450 | 380 | 500–600 | Median of 3 sources |
| General cutting | 810 | 600 | 810 | 800–1,200 | Median of 3 sources |
| Finishing | 1,240 | 1,100 | 1,240 | 1,200–1,800 | Median of 3 sources |
Each maker’s figure for the band that holds 6 in, as its manual prints it; where 6 in sits on the edge of two bands the slower band is read. A dash means that chart stops short of this size. At the general-cutting speed the rim of the blank travels 1,272 ft/min (π × 6 × 810 ÷ 12).
Sources: JET, JWL-1442VS wood lathe operating instructions: speed by diameter of work (p. 4); Grizzly, G0632 16" × 42" variable speed wood lathe manual: speed recommendations (Figure 28); Delta, 46-700 wood lathe manual: recommended spindle speeds.
The diameter × RPM rule of thumb
Blank diameter in inches × RPM of about 6,000 for roughing, up to about 9,000 for finishing. For a 6 in blank that is about 1,000 RPM roughing (6,000 ÷ 6) up to about 1,500 RPM finishing (9,000 ÷ 6). It is a turners’ rule of thumb, not a measurement, so it sits beside the makers’ figures rather than changing them.
Traditional rule, stated by Turn a Wood Bowl and Simple Woodturning Tools
Speed and safety
Turn larger and out-of-balance work slower: speed drops as the diameter grows, and an unbalanced blank wants a lower speed still.
Delta: change speed only while the lathe is running.
One source: Delta, the maker of that lathe , sources [4]
OSHA requires a wood lathe’s cutting heads to be covered as completely as possible by hoods or shields (1910.213(o)(2)).
One source: OSHA, the federal standard , sources [5]
Sources
- JET, JWL-1442VS wood lathe operating instructions: speed by diameter of work (p. 4), read 2026-11-07
- Laguna Tools, Revo 24|36 lathe manual (troubleshooting: an unbalanced job wants a slower speed), read 2026-11-07
- Woodcraft, "Expert Answers: Safe Turning Speeds" (Mike Kehs, Woodcraft Magazine), read 2026-11-07
- Delta, 46-700 wood lathe manual: recommended spindle speeds, read 2026-11-07
- OSHA, 29 CFR 1910.213, Woodworking machinery requirements, read 2026-11-07